Learning The Secrets About Plumbing

Camden Plumbing: When to Replace Water Heaters You can repair a water heater that is not heating up or leaking rather than replacing it, and regular maintenance can extend the life of your water heater when followed. Simple repairs like replacing a heating element or pressure-relief valve can resolve water heater issues and learning some troubleshooting tips can help you in managing your own water heater problems. There are simple water heater repairs that can be done DIY but if you are not comfortable working with your water heater, you can always call a professional like Camden Plumbing Consultant. Basing on most manufacturers, the suggested service lifespan of a water heater is eight to twelve years. According to a Camden Plumbing Consultant, it is best to replace your water heater if it is already more than 10 years old, with noticeable leaks surrounding the base of the tank, not working, or erratically works. The most common problem connected with a water heater is that the water is not as hot as you expected or you want it to be, which is usually caused by a defective heating element, or a faulty thermostat. It is essential to make sure that your electric water heater is maintained properly, ensuring that the power is connected, resetting the thermostat as needed, flushing the heater to eliminate sediments from the tank, replacing thermostat and heating element, and raising thermostat temperature. For gas water heater, ensure that the pilot is lit and the gas is connected, remove sediment by flushing, insulate hot water pipes, replace the Thermo coupler and clean the burner, and raise the temperature setting on the thermostat. Buildup of sediments in the tank may cause sizzling or hissing noises, so it is important to drain the tank until the water clears. Removal and soaking of elements in a pan filled with vinegar should be done for up to an hour, and collected scale are scraped off. You have to replace leaking pressure-relieve valve as needed. Replacement of water fittings should be done if tightening them does not work. Draining your water heater twice a year removes sediments high causing corrosion, and increases efficiency. One way to test the pressure-relief valve is lifting the handle of the valve and allowing it t snap back, that should release a burst of water, otherwise, a new valve should be installed. If you will choose to replace your water heater, the important features you need to check are the gallon capacity, recovery rate, dimensions, and energy efficiency ratings. Allow Camden Plumbing Consultant to help you with your water heater replacement needs, please visit their website or homepage, or contact them directly.If You Think You Get Services, Then This Might Change Your Mind

The Key Elements of Great Experts